- 2020年09月17日 16:36 Benefiting from the national industrial policy and the huge demand
- 2020年09月10日 16:09 The design of injection molds mostly uses a variety of general-purpose
- 2020年09月03日 16:20 The shape of the car body and the engine are the two key
- 2020年08月26日 15:55 Middle and low end produced by the domestic mold industry
- 2020年08月18日 15:50 The diameter deviation of the colored and interrupted parts
- 2020年08月13日 15:42 The first layer was constructed in the same way
- 2020年08月07日 14:44 The mold manufacturer must do a rigorous process and formulate
- 2020年07月28日 11:51 The greater the quality is difficult to guarantee
- 2020年07月22日 14:49 The use of molds is often determined by process design
最新の日記
| 日 | 月 | 火 | 水 | 木 | 金 | 土 |
|---|---|---|---|---|---|---|
| 29 | 30 | 1 | 2 | 3 | 4 | 5 |
| 6 | 7 | 8 | 9 | 10 | 11 | 12 |
| 13 | 14 | 15 | 16 | 17 | 18 | 19 |
| 20 | 21 | 22 | 23 | 24 | 25 | 26 |
| 27 | 28 | 29 | 30 | 31 | 1 | 2 |
- Benefiting from the national industrial policy and the huge demand
- The design of injection molds mostly uses a variety of general-purpose
- The shape of the car body and the engine are the two key
- Middle and low end produced by the domestic mold industry
- The diameter deviation of the colored and interrupted parts